Arduino based VDI!

[Nandor]

Nice, nice really nice!

[CDI]

Here is the short video in zero disc on pot...
https://youtu.be/I_7Jd4NnBTY

[Nandor]

Looking good!

[CDI]

Looking good!

Thank's man, i will post setup and code soon...

[blobber]

Here is the short video in zero disc on pot...
https://youtu.be/I_7Jd4NnBTY

Well done CDI!

[dgm]

Nice job done really well good!!!!

[jeoo888]

Did you finish it? cdi

[CDI]

OLED setup

Here is, also there is a connection on the picture for i2c setup. For sensors u need to to connect A0 and A1 pins to pin 1 and pin 14 to (U3) LF347. One of the most important thing is that the machine and Arduino board need to use separate battery.

[CDI]

Connection

i2c connection...

For Arduino board, ofcourse it can be used Nano, Micro, Mega, etc... On this picture Uno is used as example, connection pins are the same for all of them, personaly i'm using nano cause fits nice to my case.

[cvele]

Reeealy nice!! BRAVO!

[CDI]

Reeealy nice!! BRAVO!

Hvala Cvele. Thank's Cvele.

[jeoo888]

CDI Can you send the complete code?

[CDI]

CDI Can you send the complete code?

What is the problem? Lazy to copy from this txt document to Arduino .ino file format?

[Tibuck19]

CDI your using Pin 1 and pin 14 of the LF347 as X and Y , I have the EDU board it doesn't have the lf347 , have any idea which pins I have to use? pin 6 of both the lm308 ?

[CDI]

CDI your using Pin 1 and pin 14 of the LF347 as X and Y , I have the EDU board it doesn't have the lf347 , have any idea which pins I have to use? pin 6 of both the lm308 ?

I don't know for TGSL board's, never connected vdi to tgsl, but from what i remember in the tgsl thread, you need one small extra board. It should be both of pin's 6.