Tweet
bara questions
hi guys received my bara today through silverdog and its exellent top quality board and components i highly recommend
if this is the quality of his kits im definately building a tsgl next!
i have a couple of questions though for the md gurus:-
1 how and where do i connect a pot for volume? (if it intails an add on amp board and volume control thats fine but i dont want to add this if it can be wired direct!)
2 as i understand it removing mp102 results in a dc supply to run leds or vibro units is it possible to intercept this line and add a switch? (to add a silent mode i know its not as simple as that but you get the idea i will post a couple of schematics of my idea later)
3 it seems my scope is dead so i wont be playing with damping resistors is the one in the kit r1 330 sufficent for the basic coil specs posted in the threads? (wont be able to get a new scope till september and i want to build now and refine later)
thanks aly
if this is the quality of his kits im definately building a tsgl next!
i have a couple of questions though for the md gurus:-
1 how and where do i connect a pot for volume? (if it intails an add on amp board and volume control thats fine but i dont want to add this if it can be wired direct!)
2 as i understand it removing mp102 results in a dc supply to run leds or vibro units is it possible to intercept this line and add a switch? (to add a silent mode i know its not as simple as that but you get the idea i will post a couple of schematics of my idea later)
3 it seems my scope is dead so i wont be playing with damping resistors is the one in the kit r1 330 sufficent for the basic coil specs posted in the threads? (wont be able to get a new scope till september and i want to build now and refine later)
thanks aly